I divided the brine recipe by four, and then multiplied the results by five, giving me five quarts of brine. Cutting the loins in half, I injected 2 3/4 oz. of brine and then submerged the pieces in the remaining brine for 24 hours.
I realize that 60° SAL brine is rather stout and the recipe recommends slicing up and frying a sample after the 24 hours soak. However, I didn`t, fully expecting an outside piece to be too salty anyway, but also expecting the salt levels to balance during the hanging time; from brine to smoker.
Having never attempted lacing any type of meat, I gave it a go and trussed up the loins, and then gave them the required resting time. Before placing in the smoker, I even gave the larger loins an egg yolk bath.

After holding at 120°F for two hours, I gave them apple wood smoke for four hours, gradually raising the temperature of smoker to 170°F. The smaller pieces reached 140°F in eighteen hours, and the larger required an additional three hours.

This morning, after the necessary photos were taken, I sliced one for a sample, and was rewarded with a smokey meat flavored piece of salt.

As there is an abundance of salt along with the cure#1, I feel comfortable soaking the smoked loins in clear water to draw out some salt, and then hang to dry. I was planning to soak for one hour per inch diameter, or about three to four hours. Then hang for a couple hours to dry.
I`m certainly open to other suggestions and comments.
Jim